Mitsubishi Galant

1990-2001 of release

Repair and car operation


Mitsubishi Galant
+ Identification numbers of the car
+ Controls
+ Options and routine maintenance
- The engine
   - Removal/installation of the power unit, dismantle of components
      The general information
      Removal and engine installation
      Removal and installation of a cover of a head of cylinders
      Removal and installation of assemblages of a drive of valves
      Removal and thermostat installation
      Removal and installation of the inlet pipeline
      Removal and installation of a final collector
      Removal and installation турбокомпрессора
      Removal and installation of a radiator of system of cooling (all models)
      Removal and installation of the fan of system of cooling of the engine
      Removal and installation of the water pump
      Removal and installation of a head of cylinders
      Removal and pallet installation картера the engine
      Removal and installation of the oil pump
      Removal and installation демпфера крутильных fluctuations of a cranked shaft
      Removal and installation of a cover of drive ГРМ and газораспределительного a belt
      Replacement of a forward epiploon of a cranked shaft
      Removal and installation of camshafts and pushers of a drive of valves, check of a condition of components
      Removal and installation of a balancing shaft
      Replacement of a back epiploon of a cranked shaft
      Removal and installation of a flywheel/privodnogo of a disk
   + Regenerative repair of the engine
+ Cooling and heating systems
+ The power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Manual transmission
+ Coupling and transmission a line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Removal and installation of a flywheel/privodnogo of a disk

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped by a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action!

2. Remove transmission.
3. On models with РКПП remove coupling assemblage (Coupling and transmission a line see the Head).

4. Mark position of a flywheel/privodnogo of a disk concerning a cranked shaft and turn out fixing bolts.

5. On models with АТ remove the adapter приводного a disk.

6. Remove a flywheel/privodnoj a disk from the engine.


Installation

 PERFORMANCE ORDER

1. Grease fixing bolts with special hermetic for fixing of carving connections.

2. Connect assemblage of a flywheel/privodnogo of a disk to a flange of a cranked shaft.
3. On models with АТ establish the adapter приводного a disk.
4. Screw fixing bolts and tighten them with demanded effort (135 H•м: for l models 1.5; 130 ÷ 140 H•м: for l models 1.6, 2.0 l and 2.4 l; 100 H•м: for models 1.8 of l and 53 ÷ 56 H•м: for models 3.0 of l and 3.5).
5. On models with РКПП establish into place coupling assemblage (Coupling and transmission a line see the Head).
6. Establish transmission.
7. Connect a negative wire to the battery.