Mitsubishi Galant

1990-2001 of release

Repair and car operation



Mitsubishi Galant
+ Identification numbers of the car
+ Controls
+ Options and routine maintenance
+ The engine
+ Cooling and heating systems
+ The power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Manual transmission
+ Coupling and трансмиссионная a line
- Brake system
   Specifications
   Replacement of the gauge-switch of stoplights
   Removal and installation ГТЦ
   Adjustment of a pedal of a foot brake
   Check of serviceability of functioning/tightness, removal and installation of the vacuum amplifier of brakes
   Removal and valve-regulator installation
   Removal and installation of brake lines
   Prorolling of brake system
   Disk brake mechanisms - the general information
   Estimation of a condition brake колодок
   Replacement колодок disk brake mechanisms
   Removal and installation of supports of disk brake mechanisms
   Regenerative repair of a support of the disk brake mechanism
   Removal, check of a condition and installation of a brake disk
   Drum-type brake mechanisms - the general information
   Removal, installation and check of a condition of a brake drum
   Check of a condition of brake boots
   Removal and installation of brake boots
   Adjustment of drum-type brake mechanisms
   Removal, regenerative repair and installation of wheel cylinders
   Removal and cable installation (ов) a drive of a lay brake
   Adjustment of a lay brake
   Removal and installation of frictional boots of a lay brake (model with disk brake mechanisms of back wheels)
   System of antiblocking of brakes (ABS) - the general information, a problem diagnostics and codes of malfunctions
   Removal and installation of the hydraulic modulator
   Removal and installation of the block of management ABS
   Removal and installation of wheel gauges
   Removal and installation of gauges of accelerations (G-gauges)
   Replacement of rotors of wheel gauges
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Adjustment of a pedal of a foot brake

Adjustment of height of position of a pedal

 PERFORMANCE ORDER

1. Measure position Height колодки pedals concerning the floor panel (without a carpet covering). If the result of measurement falls outside the limits an admissible range (176 181 mm), make corresponding updating (see further).

2. Disconnect electroconducting from the gauge-switch of stoplights.
3. Release a counternut and take away the gauge-switch from a pedal so.

4. Release a counternut of a cutting finger of a rod of a pusher and rotation of the last adjust height of position of a pedal, - rotate a rod flat-nose pliers. Having achieved satisfactory result, tighten a counternut.

5. Return the gauge-switch of stoplights in regular position (the Section Replacement of the gauge-switch of stoplights see) and tighten a counternut.
6. Connect to the gauge-switch electroconducting.
7. Check up serviceability of functioning of stoplights (the Section Replacement of the gauge-switch of stoplights see).


Adjustment of a free course of a pedal

 PERFORMANCE ORDER

1. At the muffled engine some times squeeze out a pedal of a foot brake for the purpose of dump of residual depression in the vacuum amplifier.

2. Completely having dumped depression in the amplifier, press a pedal a hand and estimate size of its course till the moment of occurrence of resistance. Demanded value makes 3 8 mm.

3. At excessively low size of a free course of a pedal check up correctness of adjustment of the gauge-switch of stoplights.
4. Excessive люфт it is usually connected with deterioration of a cutting finger / its pin or a basic arm of a pedal. Replace defective components.