Mitsubishi Galant

1990-2001 of release

Repair and car operation


Mitsubishi Galant
+ Identification numbers of the car
+ Controls
+ Options and routine maintenance
+ The engine
+ Cooling and heating systems
+ The power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Manual transmission
+ Coupling and transmission a line
- Brake system
   Specifications
   Replacement of the gauge-switch of stoplights
   Removal and installation ГТЦ
   Adjustment of a pedal of a foot brake
   Check of serviceability of functioning/tightness, removal and installation of the vacuum amplifier of brakes
   Removal and valve-regulator installation
   Removal and installation of brake lines
   Prorolling of brake system
   Disk brake mechanisms - the general information
   Estimation of a condition brake колодок
   Replacement колодок disk brake mechanisms
   Removal and installation of supports of disk brake mechanisms
   Regenerative repair of a support of the disk brake mechanism
   Removal, check of a condition and installation of a brake disk
   Drum-type brake mechanisms - the general information
   Removal, installation and check of a condition of a brake drum
   Check of a condition of brake boots
   Removal and installation of brake boots
   Adjustment of drum-type brake mechanisms
   Removal, regenerative repair and installation of wheel cylinders
   Removal and cable installation (ов) a drive of a lay brake
   Adjustment of a lay brake
   Removal and installation of frictional boots of a lay brake (model with disk brake mechanisms of back wheels)
   System of antiblocking of brakes (ABS) - the general information, a problem diagnostics and codes of malfunctions
   Removal and installation of the hydraulic modulator
   Removal and installation of the block of management ABS
   Removal and installation of wheel gauges
   Removal and installation of gauges of accelerations (G-gauges)
   Replacement of rotors of wheel gauges
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Removal and installation of the block of management ABS

Site and details of installation ECU ABS on models Galant and Diamante

1 — the Contact socket of electroconducting ECU
2 — ECU

3 — the Basic arm


Site and details of installation ECU ABS on models Mirage

1 — ECU

2 — the Basic arm


Removal

 PERFORMANCE ORDER

1. The site and details of installation of assemblage ECU ABS is shown on illustrations.
2. Switch off ignition.

Ignition should remain switched off during all time of performance of procedure.

3. On models Galant and Diamante remove the left lateral panel of an upholstery of a luggage space.
4. On models Mirage remove floor section of the central console.
5. Release a clamp in the bottom part of a multicontact socket and disconnect electroconducting from the management block (ECU) ABS.
6. Give fixing nuts and remove ECU from the basic arm. In case of need the arm also m to be dismantled.


Installation

 PERFORMANCE ORDER

1. If removed, establish into place a basic arm of the block of management.
2. Establish the block of management and strongly tighten nuts of its fastening.
3. If removed, connect to an arm the grounding tyre, - grounding should be restored before connection to ECU electroconductings. Make sure of reliability of fixing of the contact plug.
4. Connect to the management block a multicontact socket of electroconducting, - track reliability защелкивания a clamp.
5. Establish the panel of an upholstery of luggage branch / floor section of the central console.