Mitsubishi Galant

1990-2001 of release

Repair and car operation



Mitsubishi Galant
+ Identification numbers of the car
+ Controls
+ Options and routine maintenance
+ The engine
+ Cooling and heating systems
+ The power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Manual transmission
+ Coupling and трансмиссионная a line
- Brake system
   Specifications
   Replacement of the gauge-switch of stoplights
   Removal and installation ГТЦ
   Adjustment of a pedal of a foot brake
   Check of serviceability of functioning/tightness, removal and installation of the vacuum amplifier of brakes
   Removal and valve-regulator installation
   Removal and installation of brake lines
   Prorolling of brake system
   Disk brake mechanisms - the general information
   Estimation of a condition brake колодок
   Replacement колодок disk brake mechanisms
   Removal and installation of supports of disk brake mechanisms
   Regenerative repair of a support of the disk brake mechanism
   Removal, check of a condition and installation of a brake disk
   Drum-type brake mechanisms - the general information
   Removal, installation and check of a condition of a brake drum
   Check of a condition of brake boots
   Removal and installation of brake boots
   Adjustment of drum-type brake mechanisms
   Removal, regenerative repair and installation of wheel cylinders
   Removal and cable installation (ов) a drive of a lay brake
   Adjustment of a lay brake
   Removal and installation of frictional boots of a lay brake (model with disk brake mechanisms of back wheels)
   System of antiblocking of brakes (ABS) - the general information, a problem diagnostics and codes of malfunctions
   Removal and installation of the hydraulic modulator
   Removal and installation of the block of management ABS
   Removal and installation of wheel gauges
   Removal and installation of gauges of accelerations (G-gauges)
   Replacement of rotors of wheel gauges
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Replacement of the gauge-switch of stoplights

Removal

 PERFORMANCE ORDER

1. The Gauge-switch of stoplights is fixed on an arm of a pedal of a foot brake by means of a counternut.

2. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped by a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action!

3. Disconnect electroconducting from the gauge-switch of stoplights.
4. Release a counternut and remove the gauge-switch from a pedal arm.


Installation

 PERFORMANCE ORDER

1. Establish the new gauge-switch on an arm of a pedal of a foot brake, screw and slightly tighten a counternut.

2. Modify gauge-switch position so that the distance between its case and a pedal made 0.5 1.0 mm, - for switching-off of stoplights плунжер the gauge-switch should rest against a pedal. At pedal squeezing плунжер it is released, that leads to operation of stoplights.

3. Keeping the gauge-switch in demanded position, strongly tighten a counternut.
4. Connect to the gauge-switch electroconducting.
5. Check up serviceability of functioning of the gauge-switch for what include ignition (the engine do not start) and ask to squeeze out some times the assistant a pedal of a foot brake, - stoplights should work unequivocally at each squeezing already in the beginning of a course of a pedal.
6. In case of need repeat process регулриовки.

Insignificant люфт to a pedal should not lead to operation of the gauge-switch in order to avoid not authorised activation of stoplights at car movement on a rough road covering.