|
1. Remove brake drums (the Brake system see the Head).
|
|
2. Make careful cleaning of brake mechanisms with application of special cleaning structure.
|
|
At all do not blow off a brake dust from a surface of components the compressed air and do not inhale it is a dust can contain asbestos harmful to your health! |
Estimate a residual thickness of frictional overlays of brake boots (forward and back), check up components on presence of traces of pollution by a brake liquid and oil. If the frictional overlay acts over heads of rivets / a metal substrate of assemblage less than on 1.6 mm, boots are subject to replacement in the complete set (the Brake system see the Head). It is necessary to replace boots also in case of revealing of cracks, заполированных to shine of sites of overlays, or traces of hit of a brake liquid. |
3. Make sure of correctness of connection and serviceability of a condition of all springs of assemblage of the brake mechanism (the Brake system see the Head). The neglect replacement of the deformed or weakened springs is fraught with premature deterioration of boots as a result “прихватывания” brakes.
4. Check up assemblage components on presence of traces of leaks of a brake liquid. Cautiously having hooked a finger or a small screw-driver, remove rubber пыльники from the wheel cylinder in the top part of boots. Revealing of any signs of leaks in these places demands carrying out of immediate regenerative repair of assemblage of the cylinder (the Brake system see the Head). Also check up on presence of traces of leaks all brake hoses and them штуцерные connections.
5. Carefully wipe internal surfaces of a drum the pure rags impregnated with methyl spirit. Try not to inhale a brake dust containing asbestos. Examine a working surface of a drum on presence of cracks, задиров, traces of an overheat and other damages. If defects cannot be removed by processing of a surface by a fine-grained emery paper, it is necessary to give a drum for проточки to a car-care centre workshop (the Brake system see the Head).
6. Repeat procedure for components of the opposite brake mechanism. Establish into place drums, fix wheels and lower the car on the earth. Tighten wheel nuts with demanded effort. |