Mitsubishi Galant

1990-2001 of release

Repair and car operation



Mitsubishi Galant
+ Identification numbers of the car
+ Controls
+ Options and routine maintenance
+ The engine
+ Cooling and heating systems
+ The power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Manual transmission
- Coupling and трансмиссионная a line
   Specifications
   Coupling - the general information and check of a condition of components
   Removal, check of a condition and installation of components of assemblage of coupling
   Removal, check of a condition and installation выжимного the bearing and a plug of deenergizing of coupling
   Check of a condition and replacement of the directing bearing
   Adjustment of a pedal of coupling
   Adjustment of a cable of a drive of coupling, removal and installation тросовой assemblages (models Mirage with тросовым a coupling drive)
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Removal of air from a hydraulic path of a drive of deenergizing of coupling
   Removal and installation of power shafts
   Hinges of power shafts - the general information and service
   Condition check трансмиссионной lines
   Removal and installation карданного a shaft
   Replacement карданного the hinge
   Balancing карданного a shaft
   Removal and installation of assemblage of the central bearing карданного a shaft
   Removal and installation of back semiaxes (model AWD Galant on 1993 вып.)
   Removal and installation ступичной pins of a back axis, the wheel bearing and an epiploon
   Replacement of an epiploon of a leading gear wheel of back differential
   Removal and installation картер back differential (model AWD Galant on 1993 вып.)
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Removal and installation of the main cylinder of coupling

Removal

 PERFORMANCE ORDER

1. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped by a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action!

2. Remove located in an impellent compartment and blocking access to assemblage of the main cylinder of coupling components.
3. Get under the car suitable capacity and prepare rags for gathering spilling at a detachment of hydraulic lines of a liquid.
4. Release штуцерный a socket of the hydraulic line brought to the cylinder and merge from it a liquid in the prepared capacity.

The liquid merged from a path is not subject to a reuse and should be utilised according to regional laws on preservation of the environment. Remember also, that the hydraulic liquid is an aggressive chemical compound and is capable to damage ЛКП at hit on painted кузовные surfaces!

5. Disconnect a cutting finger of fastening of a pusher of the cylinder to a coupling pedal. Remove a washer and disconnect a pusher.
6. Give the gauge-switch fixing nuts and remove assemblage of the cylinder from a back partition of an impellent compartment.

Between a landing flange of the cylinder and an interfaced surface of a partition the sealing lining subject to replacement is established.


Installation

 PERFORMANCE ORDER

1. Installation is made upside-down. Do not forget to grease all contact and basic knots.
2. Having finished assemblage, "pump over" a hydraulic path, completely having removed from it air stoppers (see Has undressed Removal of air from a hydraulic path of a drive of deenergizing of coupling).