Mitsubishi Galant

1990-2001 of release

Repair and car operation



Mitsubishi Galant
+ Identification numbers of the car
+ Controls
+ Options and routine maintenance
+ The engine
+ Cooling and heating systems
+ The power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Manual transmission
- Coupling and трансмиссионная a line
   Specifications
   Coupling - the general information and check of a condition of components
   Removal, check of a condition and installation of components of assemblage of coupling
   Removal, check of a condition and installation выжимного the bearing and a plug of deenergizing of coupling
   Check of a condition and replacement of the directing bearing
   Adjustment of a pedal of coupling
   Adjustment of a cable of a drive of coupling, removal and installation тросовой assemblages (models Mirage with тросовым a coupling drive)
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Removal of air from a hydraulic path of a drive of deenergizing of coupling
   Removal and installation of power shafts
   Hinges of power shafts - the general information and service
   Condition check трансмиссионной lines
   Removal and installation карданного a shaft
   Replacement карданного the hinge
   Balancing карданного a shaft
   Removal and installation of assemblage of the central bearing карданного a shaft
   Removal and installation of back semiaxes (model AWD Galant on 1993 вып.)
   Removal and installation ступичной pins of a back axis, the wheel bearing and an epiploon
   Replacement of an epiploon of a leading gear wheel of back differential
   Removal and installation картер back differential (model AWD Galant on 1993 вып.)
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Replacement карданного the hinge

Removal

 PERFORMANCE ORDER

1. Mark landing position of the hinge in the case of the collar. By means of special flat-nose pliers remove lock rings.
2. By means of the big clamp squeeze out of a collar подшипниковые necks крестовины: on a motionless part of a clamp the plug of the suitable size in which the neck is squeezed out is established, - in case of need knock on a collar with a hammer with soft the brisk. Having liberated a neck, take the bearing. Operating in a similar manner, remove the remained bearings and take крестовину.


Installation

 PERFORMANCE ORDER

1. Grease with universal greasing подшипниковые necks, маслосборники, sponges пыльников and needle roller bearings replaceable карданного the hinge.

Be not overzealous, - surplus of greasing can lead to errors at selection of lock rings and to damage of covers of bearings.

2. By means of a clamp запрессуйте bearings in a collar also fix their new lock rings equal on a thickness removed in the course of dismantle of assemblage. Definitive застукивание necks 15 mm can be made by means of brass выколотки in diameter.
3. With the help щупа лезвийного type define backlashes of planting of lock rings in the flutes. If the result of measurement falls outside the limits an admissible range (0.02 0.06 mm), the corresponding ring is subject to replacement.