Mitsubishi Galant

1990-2001 of release

Repair and car operation



Mitsubishi Galant
+ Identification numbers of the car
+ Controls
+ Options and routine maintenance
+ The engine
+ Cooling and heating systems
+ The power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Manual transmission
- Coupling and трансмиссионная a line
   Specifications
   Coupling - the general information and check of a condition of components
   Removal, check of a condition and installation of components of assemblage of coupling
   Removal, check of a condition and installation выжимного the bearing and a plug of deenergizing of coupling
   Check of a condition and replacement of the directing bearing
   Adjustment of a pedal of coupling
   Adjustment of a cable of a drive of coupling, removal and installation тросовой assemblages (models Mirage with тросовым a coupling drive)
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Removal of air from a hydraulic path of a drive of deenergizing of coupling
   Removal and installation of power shafts
   Hinges of power shafts - the general information and service
   Condition check трансмиссионной lines
   Removal and installation карданного a shaft
   Replacement карданного the hinge
   Balancing карданного a shaft
   Removal and installation of assemblage of the central bearing карданного a shaft
   Removal and installation of back semiaxes (model AWD Galant on 1993 вып.)
   Removal and installation ступичной pins of a back axis, the wheel bearing and an epiploon
   Replacement of an epiploon of a leading gear wheel of back differential
   Removal and installation картер back differential (model AWD Galant on 1993 вып.)
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Replacement of an epiploon of a leading gear wheel of back differential

Removal

 PERFORMANCE ORDER

1. Поддомкратьте the car also establish it on props.
2. Having marked landing position of components, disconnect карданный a shaft from a flange of differential and tie up its wire to elements of the bottom of the car.
3. Keeping a connecting flange from проворачивания, give located in its centre big самоконтрящуюся a nut.
4. By means of a stripper dismantle a flange and take an epiploon of a leading gear wheel of differential.


Installation

 PERFORMANCE ORDER

1. Slightly grease with universal greasing of a sponge of a new epiploon and a surface of a connecting flange contacting to it. By means of approaching оправки plant an epiploon on the regular place.
2. Establish a connecting flange and tighten it самоконтрящуюся a nut with demanded effort (157 220 H•м). The twisting moment проворачивания a flange should make nearby 0.45 H•м at the new or well greased bearings.
3. Establish into place карданный a shaft.