Mitsubishi Galant

1990-2001 of release

Repair and car operation


Mitsubishi Galant
+ Identification numbers of the car
+ Controls
+ Options and routine maintenance
+ The engine
+ Cooling and heating systems
+ The power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Manual transmission
- Coupling and transmission a line
   Specifications
   Coupling - the general information and check of a condition of components
   Removal, check of a condition and installation of components of assemblage of coupling
   Removal, check of a condition and installation выжимного the bearing and a plug of deenergizing of coupling
   Check of a condition and replacement of the directing bearing
   Adjustment of a pedal of coupling
   Adjustment of a cable of a drive of coupling, removal and installation тросовой assemblages (models Mirage with тросовым a coupling drive)
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Removal of air from a hydraulic path of a drive of deenergizing of coupling
   Removal and installation of power shafts
   Hinges of power shafts - the general information and service
   Condition check трансмиссионной lines
   Removal and installation карданного a shaft
   Replacement карданного the hinge
   Balancing карданного a shaft
   Removal and installation of assemblage of the central bearing карданного a shaft
   Removal and installation of back semiaxes (model AWD Galant on 1993 вып.)
   Removal and installation ступичной pins of a back axis, the wheel bearing and an epiploon
   Replacement of an epiploon of a leading gear wheel of back differential
   Removal and installation картер back differential (model AWD Galant on 1993 вып.)
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Adjustment of a pedal of coupling

 PERFORMANCE ORDER

On models with a hydraulic drive try not to admit during performance of adjustments of a pedal отжимания a pusher towards the main cylinder of coupling!


1. Remove rugs and floor-mats of a floor covering, - as height of position of a pedal of coupling (A) is called the distance from its central part колодки to a surface of a sound-proof layer.

2. Measure distance from a floor to an external surface колодки completely released pedal. Compare result of measurement to requirements of Specifications (168 ÷ 171 mm: models Mirage and 176 ÷ 182 mm: models Galant).
3. Measure size люфта a cutting finger rather колодки pedals (the rating value makes 1 ÷ 3 mm).
4. If results of measurements falls outside the limits admissible value make corresponding updatings (see further).
5. Rotation of an adjusting bolt achieve reduction in norm of height of position of a pedal, then strongly tighten a counternut.
6. On the models equipped with a control system in the speed, disconnect electroconducting from the gauge-switch of coupling and, rotating last, modify in appropriate way height of position of a pedal.
7. Pusher rotation result in norm size люфта a cutting finger, - in summary do not forget to tighten a counternut.
8. Make sure of serviceability of operation of the gauge-switch of disconnection of a chain of a starter at full squeezing of a pedal of coupling.