Mitsubishi Galant

1990-2001 of release

Repair and car operation



Mitsubishi Galant
+ Identification numbers of the car
+ Controls
+ Options and routine maintenance
+ The engine
+ Cooling and heating systems
+ The power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Manual transmission
- Coupling and трансмиссионная a line
   Specifications
   Coupling - the general information and check of a condition of components
   Removal, check of a condition and installation of components of assemblage of coupling
   Removal, check of a condition and installation выжимного the bearing and a plug of deenergizing of coupling
   Check of a condition and replacement of the directing bearing
   Adjustment of a pedal of coupling
   Adjustment of a cable of a drive of coupling, removal and installation тросовой assemblages (models Mirage with тросовым a coupling drive)
   Removal and installation of the main cylinder of coupling
   Removal and installation of the executive cylinder of coupling
   Removal of air from a hydraulic path of a drive of deenergizing of coupling
   Removal and installation of power shafts
   Hinges of power shafts - the general information and service
   Condition check трансмиссионной lines
   Removal and installation карданного a shaft
   Replacement карданного the hinge
   Balancing карданного a shaft
   Removal and installation of assemblage of the central bearing карданного a shaft
   Removal and installation of back semiaxes (model AWD Galant on 1993 вып.)
   Removal and installation ступичной pins of a back axis, the wheel bearing and an epiploon
   Replacement of an epiploon of a leading gear wheel of back differential
   Removal and installation картер back differential (model AWD Galant on 1993 вып.)
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment





Removal and installation картер back differential (model AWD Galant on 1993 вып.)

Removal

 PERFORMANCE ORDER

1. Поддомкратьте the car also establish it on props.
2. Merge from differential трансмиссионное oil and remove the central section of system of release of the fulfilled gases.
3. Mark adjusting position and disconnect from differential the back end карданного a shaft (see Has undressed Removal and installation карданного a shaft).
4. Remove semiaxes (see Has undressed Removal and installation of back semiaxes (model AWD Galant on 1993 вып.)).
5. At a corresponding complete set remove assemblage of the steering pump of a steering drive of back wheels.
6. On the big bolts of fastening of a basic plate of differential to the car bottom can be used самоконтрящиеся nuts. Before to give nuts, prop up differential on the centre тележечным a jack. Release nuts and remove from a back part of a box of differential a basic plate () and vibrating демпфер the square form.
7. Lower assemblage of differential and take it from under the car.


Installation

 PERFORMANCE ORDER

1. Get differential on the regular place and screw bolts of a bearing beam. Replace all самоконтрящиеся nuts.
2. At a corresponding complete set establish into place the pump of a steering drive of back wheels.
3. Having replaced lock rings, establish back semiaxes.
4. Establish карданный a shaft.
5. Establish the central section of system of release of the fulfilled gases with the muffler.
6. Lower the car on the earth.
7. Fill in in картер differential fresh трансмиссионное oil.