Mitsubishi Galant

1. Prorolling of a hydraulic drive of deenergizing of coupling should be carried out each time after removal of its components and also when liquid level in the tank of the main cylinder falls so, that air gets to assemblage. A principle of prorolling the same, as used at removal of air from a brake path.
2. Fill in in the tank of the main cylinder fresh brake liquid DOT 3.

Do not use the liquid repeatedly already extorted from system, and also, a liquid, long time stored in leaky closed container.

3. Поддомкратьте the car also establish it on props, having provided with that access to the executive cylinder of coupling fixed from the forward party трансмиссионной of assemblage.
4. Remove a dustproof cap and pull on the gate of prorolling of the executive cylinder the end of a plastic hose approaching on the size. The second end of a hose lower in partially filled brake liquid a transparent vessel. Track, that the hose cut has appeared entirely is shipped in a liquid.
5. Ask to squeeze out the assistant a pedal of coupling and to fix it in the bottom position. Slightly open the gate of prorolling and let out a liquid from the cylinder in drain capacity. When вытекание the liquid mixed with air bubbles will stop, again densely tighten the gate and allow to release to the assistant a pedal.
6. Continue prorolling in the same manner until the liquid leaving the cylinder completely will not be released from air bubbles. Constantly watch closely liquid level in the tank of the main cylinder, not supposing its excessive lowering, air dangerous by hit in a path and data to zero of all undertaken efforts.
7. Having finished prorolling, disconnect a hose and establish into place a dustproof cap. In case of need add to the tank a little more a hydraulic liquid. Check up serviceability of functioning of coupling.