Mitsubishi Galant

1. Mark position of universal hinge Lobro (Lobro) concerning a connecting flange.
2. Turn out fixing bolts and separate the hinge from a flange.
3. Mark position of the central collar concerning the central section карданного a shaft, and position соединительно a flange - concerning back section.
4. Give самоконтрящиеся nuts and remove the central collar with a connecting flange.
5. Mark position of a forward arm of the central bearing concerning the central section of a shaft, back - concerning back section. Remove a basic arm of the central bearing.

Rubber pillows from an arm are not taken.

6. By means of a special stripper liberate from assemblage forward and back central bearings.

1. Fill in forward and back flutes of assemblage of the central bearing universal greasing, the same greasing натолкайте in sponges пыльника. Track, that the bearing has got to a flute of a rubber pillow of a basic arm.

Пыльник it is established by sponges towards landing labels on an arm.

2. Plant bearing assemblage on the central and back sections карданного a shaft, - track correctness of combination of landing labels.
3. Special, a part ремнабора, with greasing in regular intervals grease rubber уплотнители a connecting flange. Watching correctness of combination of landing labels, the central section of a shaft and a connecting flange, densely plant the bearing by a tightening самоконтрящихся nuts.
4. Screw and tighten bolts of fastening of hinge Lobro. Also check up assemblage on presence of signs of development of leaks through a protective cover and a connecting flange.