Mitsubishi Galant

1. As the directing bearing of coupling the needle bearing, which запрессовывается in a special nest in an end face of a back pin of a cranked shaft is used. The bearing jams greasing on manufacturer and additional greasing does not require. By means of the given bearing fixing of a forward pin of a primary shaft of a transmission is provided. Check of a condition of the bearing should be made each time at removal of components of coupling. In case of absence of confidence in fidelity of an estimation of a condition of its bearing it is necessary to replace.

If the engine is removed from the car, corresponding from resulted below steps should be lowered.

2. Remove transmission (the Manual transmission see the Head).
3. Remove coupling components (see Has undressed Removal, check of a condition and installation of components of assemblage of coupling).
4. Highlighting itself a small lamp, estimate degree of deterioration and the general condition of the directing bearing. In case of need make replacement.

5. Bearing removal can be made by means of the special tool (a hammer with sliding brisk), - ask in shops of automobile accessories.

6. There is also an alternative method of extraction of the bearing from the landing nest.
7. Prepare densely entering into a bearing nave a metal or wooden core (выколотку).

8. Fill a nest cavity under the bearing dense greasing, then start to hammer выколотку into an assemblage nave, - the bearing will be squeezed out of a pin of a shaft at the expense of hydraulic pressure developed in a cavity.

9. In quality оправки at planting in a pin of a shaft of the new bearing the face head approaching on the size, or a piece of a pipe of the corresponding diameter (hardly smaller than diameter of the bearing) can be used. Before planting it is necessary to grease an external surface of the bearing slightly. The bearing refuels in a nest the condensed party outside.

10. Establish into place coupling assemblage, a transmission and all other components acting in film for the purpose of providing of access. Track, that the corresponding fixture has been tightened with demanded effort.