Mitsubishi Galant

1990-2001 of release

Repair and car operation

Removal and installation of the central console

Details of installation of sections of the central console on models Mirage on 1992 вып.


1 — Монетница 2 — the Pocket 3 — the Switch of management of the electric drive of door mirrors/zaglushka 4 — Facing	5 — Back section of console assemblage 6 — the Handle of the lever of a gear change (РКПП) 7 — Forward section of console assemblage

Details of installation of sections of the central console on models Mirage 1993 ч 1996 of вып.


1 — the Finishing panel 2 — Заглушка 3 — Заглушка 4 — Facing 5 — the Directing framework	6 — Back section of console assemblage 7 — the Handle of the lever switching I of transfers (РКПП) 8 — the Clamp 9 — Forward section of console assemblage 10 — the Basic arm

Details of installation of sections of the central console on models Mirage since 1997 вып.


1 — Back section of console assemblage 2 — the Ashtray 3 — the Panel of facing of a radio tape recorder 4 — Forward section of console assemblage	5 — the Facing panel of the lever of the selector (АТ) 6 — Forward section of console assemblage 7 — the Basic arm

Details of installation of sections of the central console on models Galant on 1993 вып.


1 — the Facing panel of the lever of a gear change (РКПП) 2 — the Protective cover of the lever of a gear change 3 — the Coaster 4 — the Console ware box 5 — the Cover of a console ware box 6 — Loopy clamps	7 — the Switch of management of functioning of the electric drive of door mirrors 8 — the Switch of modes of movement (POWER/ECONO)/zaglushka 9 — the Switch of electronic control by system of hydrostrengthening of a wheel/zaglushka 10 — the Finishing panel 11 — Basic arms

Details of installation of sections of the central console on models Galant 1994 ч 1998 of вып.


1 — the Handle of the lever of a gear change (РКПП) 2 — the Panel of facing of the lever of a gear change 3 — the Pocket 4 — the Central (console) section of furnish of the panel of devices	5 — Forward section of console assemblage 6 — the Basic arm And 7 — the Basic arm In

Details of installation of sections of the central console on models Galant since 1999 вып.


1 — Facing of the lever of a gear change 2 — the Coaster (models without armrests) 3 — the Armrest (models with armrests) 4 — the Basic arm And (models to be with armrests) 5 — Console assemblage	6 — the Bottom central panel of furnish 7 — the Ashtray 8 — the Basic arm With 9 — the Basic arm And

Details of installation of sections of the central console on models Diamante 1992 ч 1996 of вып.


1 — the Ashtray/panel of switches 2 — the Switch/zaglushka	3 — Console assemblage

Details of installation of sections of the central console on models Diamante since 1997 вып.


1 — the Coaster 2 — Монетница 3 — the Finishing panel 4 — Lateral covers	5 — Console assemblage 6 — the Basic arm And 7 — the Basic arm With

Back section

Removal

PERFORMANCE ORDER

1. Details of installation of back section of the central console are shown on illustrations.
2. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped by a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action!
On the models equipped with a pillow (амии) of safety, wrap up a wire tip изоляционной a tape and start to work after not less than 60 seconds during which should occur switching-off SRS!

3. Open a cover of a console ware box.
4. In case of need unbend edge of a carpet covering in the bottom part of console assemblage.
5. Turn out the fixing screws located along bottom which of the back section of console assemblage.
6. In case of need Remove заглушки and turn out forward fixing screws.
7. Lift the console and take it from the car.

On some models seat belts are passed through console assemblage and they are necessary for liberating accurately from it.

Installation

PERFORMANCE ORDER

Installation is made upside-down.

Forward section

Removal

PERFORMANCE ORDER

1. Details of installation of forward section of the central console are shown on illustrations.
2. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped by a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action!
On the models equipped with a pillow (амии) of safety, wrap up a wire tip изоляционной a tape and start to work after not less than 60 seconds during which should occur switching-off SRS!

3. In case of need remove back section of the console.
4. In case of need remove an ashtray and a coaster.
5. In case of need remove carpet inserts of console assemblage.
6. On models with РКПП remove the handle from the gear change lever.
7. On models with АТ remove the facing panel of the lever of the selector.
8. Remove заглушки, turn out fixing screws and remove lateral covers of the console.
9. Remove заглушки forward fixing screws.
10. Preliminary having marked, disconnect all electroconducting brought to console assemblage.
11. Turn out fixing screws and remove console assemblage.

Installation

PERFORMANCE ORDER

Installation is made upside-down.