Mitsubishi Galant

1. Details of installation of the aerial of a radio receiver on models Mirage on 1992 вып. Are shown on an illustration.
2. Поддомкратьте the car also establish it on props.
3. Remove the right forward wheel.
4. Remove локер protection of a wheel arch.
5. For the purpose of providing of access to a radio receiver remove the central section of furnish of the panel of devices and a ware box.
6. Remove overlays of a threshold of the right forward door of the car.
7. On models with a back heater remove the air line laid under a ware box.
8. Accurately remove PCM (see the Head of the Control system of the engine).
9. Remove a radio receiver and disconnect from it an antenna cable.
10. Liberate a cable from intermediate обвязок and clamps of its fastening under the panel of devices.
11. Turn out a mast of the aerial from assemblage of its basis.
12. Give the top nut of fastening of the basis of the aerial (on a car wing) and release the bottom bolt of fastening of a mast.
13. Remove a mast and accurately liberate an antenna cable.

1. Fill in an aperture in a wing replaceable antenna assemblage and strongly tighten the top nut and the bottom bolt.
2. Cautiously get a cable under the panel of devices on connect it to a radio receiver, - track reliability of fastening of a cable in all provided clamps and обвязках.
3. Establish into place the module of management MPI.
4. If removed, establish into place an air sleeve of a heater.
5. Establish overlays of a threshold of the right forward door.
6. Establish a ware box.
7. Establish the central section of furnish of the panel of devices.
8. Establish локер protection of a wheel arch.
9. Establish a wheel and lower the car on the earth.

1. Details of installation of the aerial of a radio receiver on models Mirage since 1993 вып. Are shown on an illustration.
2. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped by a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action!

3. Turn out screws of fastening of the basis of the aerial.
4. Lift an aerial mast in gathering with the basis and separate it from a car roof.
5. Disconnect an antenna cable.

Installation is made upside-down.

1. Details of installation of the aerial of a radio receiver on models Galant and Diamante are shown on illustrations.
2. Disconnect a negative wire from the battery.

If the stereosystem established on the car is equipped by a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action!

3. Remove the lateral panel of an upholstery of a luggage space.
4. On models with the stationary aerial turn out a mast.
5. Accurately release established from above on a car wing a ring nut.
6. Disconnect electroconducting from приводного the electromotor. Disconnect an antenna cable.
7. Give fixing bolts and nuts and remove assemblage of the electromotor of a drive of the aerial.

1. Establish приводной the electromotor and tighten elements of its fixture.
2. Restore initial connection of electroconducting and an antenna cable.
3. Screw a ring nut and accurately tighten it with demanded effort (4 H•м, - is hardly stronger, than by hand).
4. On models with the stationary aerial screw a mast.
5. Establish the lateral panel of an upholstery of a luggage space.