Mitsubishi Galant

1990-2001 of release

Repair and car operation


Mitsubishi Galant
+ Identification numbers of the car
+ Controls
+ Options and routine maintenance
+ The engine
+ Cooling and heating systems
- The power supply system and release
   Specifications
   Сбрасывание pressure in the power supply system
   Removal and installation of the case of a throttle
   Removal and installation of a fuel highway and injection injectors
   Check of a condition and replacement of fuel lines and them штуцерных connections
   Check of serviceability of functioning of injectors
   Removal and installation of a regulator of pressure of fuel
   Removal and installation of a safety valve of a fuel tank
   Removal and installation of a fuel tank
   Cleaning and repair of a fuel tank - the general data
   Check of serviceability of functioning of the fuel pump, measurement of pressure of fuel
   Removal and installation of the fuel pump/gauge of the expense of fuel
   Removal and installation of assemblage of an air cleaner
   Release system
+ Engine electric equipment
+ Control systems of the engine
+ Manual transmission
+ Coupling and transmission a line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Removal and installation of a safety valve of a fuel tank

Remember that gasoline is extremely an inflammable liquid! At work with power supply system components observe all taken measures of fire safety. Do not smoke! Do not come nearer to a place of work with open fire or the redurable not protected by a lamp shade! Do not make system service in the premises equipped working on natural gas and heating devices equipped with a control torch (such as водогреи and dryers for clothes). Do not forget, that gasoline is among cancerogenic substances, i.e., - the substances promoting development of a cancer! Try not to suppose fuel hit on open sites of a body, use rubber protective gloves, at casual unforeseen contact to fuel carefully wash out hands warm water with soap. Immediately collect the spilt fuel and do not put the rags impregnated with PETROLEUM PRODUCTS near to sources of open fire. Remember that the power supply system equipped with injection of fuel of models constantly is under pressure. Before to start a detachment of fuel lines, dump residual pressure in system. At service of components of the power supply system put on goggles. Constantly hold near at hand the class fire extinguisher In!


Removal

 PERFORMANCE ORDER

1. Поддомкратьте the car also establish it on props. The valve site is shown on an illustration.

2. Disconnect hoses and remove a safety valve of a fuel tank.


Installation

 PERFORMANCE ORDER

Installation is made upside-down.

Track, that put on the case of the valve of the marksman specified in a direction of a coal adsorber of system of catching of fuel evaporations (EVAP), instead of towards a fuel tank.