Mitsubishi Galant

1. If the starter does not rotate at ignition key turn in position START, first of all make sure, that the selector lever is in position “Р” or “N” (models with АТ) in completeness of squeezing of coupling (model with РКПП).
2. Check up level of a charge of the battery, estimate a condition and reliability of fastening of contact plugs of the battery and a starter.
3. If the starter rotates regularly, however the engine does not turn, it is necessary to replace assemblage of a drive with обгонной муфтой.
4. If the starter is not turned, despite serviceable щелканье the traction relay, the cause of a failure can be covered in malfunction of a condition of the storage battery, oxidation of the main contact plugs of a starter, or failure actually the electromotor стартерной assemblages. The probability of jamming of the engine is not excluded also.
5. If at поворачивании a key of any clicks it is not audible, it is necessary to check up a condition of the battery, a protective fusible insert of a chain of start and the relay of inclusion of a starter. Probably, actually magnetic actuator is faulty.
6. Having disconnected bobbin assemblage, deactivate ignition system. Make sure, that engine start is not obviously possible.
7. Connect the voltmeter between the positive plug of the battery and the plug In + a starter.
8. Turn the ignition key in position START and consider the voltmeter indication.
9. If the result of measurement exceeds value 0.5 In breakage or short circuit in electroconducting of a chain of a starter, hence, takes place, - make necessary regenerative repair. If pressure is perfectly in order, pass to a following stage of check.
10. Connect the voltmeter between the positive plug of the battery and M.Povernite's plug a key in position START and consider the indication.
11. If the result of measurement exceeds value 0.5 In breakage or short circuit in electroconducting of a chain of a starter, hence, takes place, - make necessary regenerative repair.
12. More detailed check of a starter can be made on a workbench with application of a special diagnostic tester, - ask with shops of automobile accessories.