Mitsubishi Galant

1990-2001 of release

Repair and car operation


Mitsubishi Galant
+ Identification numbers of the car
+ Controls
+ Options and routine maintenance
+ The engine
+ Cooling and heating systems
- The power supply system and release
   Specifications
   Сбрасывание pressure in the power supply system
   Removal and installation of the case of a throttle
   Removal and installation of a fuel highway and injection injectors
   Check of a condition and replacement of fuel lines and them штуцерных connections
   Check of serviceability of functioning of injectors
   Removal and installation of a regulator of pressure of fuel
   Removal and installation of a safety valve of a fuel tank
   Removal and installation of a fuel tank
   Cleaning and repair of a fuel tank - the general data
   Check of serviceability of functioning of the fuel pump, measurement of pressure of fuel
   Removal and installation of the fuel pump/gauge of the expense of fuel
   Removal and installation of assemblage of an air cleaner
   Release system
+ Engine electric equipment
+ Control systems of the engine
+ Manual transmission
+ Coupling and transmission a line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Release system

It is necessary to start service of system of release only after full cooling of its components, - remember, that the surface каталитического the converter while in service the car can heat up to very heats! Track reliability of fixing of the car in the lifted position.


The general information

Models considered in the present Management are completed with system of release of the fulfilled gases of one of two types. In one design for a joint among themselves system sections are used equipped with sealing linings and pulled together with bolts фланцевые connections, in another are applied sliding хомутные couplers.

Whereas while in service the car components of system of release of the fulfilled gases constantly are exposed to aggressive influences of environment and heats, assemblage components can appear “tightly become attached” to each other, therefore, before to start to отпусканию fixture, it is necessary to impregnate joints of corresponding sections with getting oil. In especially heavy cases it is necessary to take advantage ножовкой, a chisel or autogenous cutting. Will charge most correctly performance of replacement of components of system to experts of car-care centre.

Check of a condition of components

 PERFORMANCE ORDER

1. The condition of components of system of release of the fulfilled gases should be checked on a regular basis according to the Schedule of routine maintenance of the car (see the Head of Adjustment and routine maintenance).
2. Поддомкратьте the car also establish it on props. Remove limiting sector of the review and access thermofilters.
3. Check should be begun with survey of a joint of a reception pipe of system of release of the fulfilled gases with a final collector / турбокомпрессором.
4. Attentively examine system on all its length, checking sections and components on presence of deformations, traces of the leaks, the dispersed seams and other defects of a mechanical order.
5. Estimate a condition rubber подвесов system support. Defective units replace.