Mitsubishi Galant
+ Identification numbers of the car
+ Controls
+ Options and routine maintenance
+ The engine
- Cooling and heating systems
Specifications
Antifreeze - the general data
Check of serviceability of functioning and the thermostat
Check of a condition of the fan of system of cooling
Removal and installation of a radiator of system of cooling
Check of a condition of the water pump
Removal and installation of the water pump
Check of serviceability of functioning and replacement of the block of the gauge of a measuring instrument of temperature of a cooling liquid
Replacement of the electromotor of a drive of the fan of a heater
Removal and installation of the heat exchanger of a heater
Check of serviceability of functioning and service of systems of heating and air conditioning
Removal and installation of assemblage of the control panel by functioning of a heater and air conditioner, adjustment приводных cables
+ The power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Manual transmission
+ Coupling and transmission a line
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
|
Removal and installation of assemblage of the control panel by functioning of a heater and air conditioner, adjustment приводных cables
|
|
Cars considered in the present Management are equipped by system of the additional safety SRS more known as a pillow of safety. Before to perform any works near to assemblage of a pillow or a steering column, without fail disconnect system in order to avoid reception of traumas as a result of its casual operation, - disconnect from the battery at first negative, then for a positive wire and wait not less than two minutes before to start service of the components located near to gauges of directed overloads (the Onboard electric equipment see the Head). Isolation and contact sockets of electroconducting of chain SRS are painted in bright yellow colour. It is not necessary to connect any diagnostic devices to the given chain! |
Removal
| |
| 1. Disconnect a negative wire from the battery.
|
|
If the stereosystem established on the car is equipped by a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action! |
2. Release clamps and remove the central section of furnish of the panel of devices (the Body see the Head).
3. Remove a radio tape recorder/CD player.
|
4. Turn out screws of fastening of the control panel functioning of a heater/conditioner of air Wring out a lever finger and disconnect a cable демпфера switchings of distribution of air. Disconnect other приводные cables and electroconducting. By means of nippers release a clamp and remove assemblage of the control panel from the car. |
|
|
Installation
| |
| 1. Translate the handle of a choice of a temperature mode in position the MOVE of NOTES (the maximum heating).
2. Приводной the lever distributing демпфера on heater assemblage also translate in position the MOVE of NOTES, then connect to a lever finger приводной a cable.
3. Delay a cable cover in a direction specified маркерной by an arrow, having provided assemblage a necessary weak point, then fix a cable by means of a clip.
4. Translate the handle of a choice of a direction of distribution of air in position обдува a windscreen (DEF). In the same position establish приводной the lever corresponding демпфера on heater assemblage, then connect to a lever finger приводной a cable.
5. Delay a cable cover in a direction specified маркерной by an arrow, having provided assemblage a necessary weak point, then fix a cable by means of a clip.
6. Translate the lever of a choice of a mode of air circulation on the control panel in a mode of the closed circulation. In corresponding position translate приводной the lever corresponding демпфера on heater assemblage. Connect a cable to a lever finger.
7. Delay a cable cover in a direction specified маркерной by an arrow, having provided assemblage a necessary weak point, then fix a cable by means of a clip.
8. In the correct image place management assemblage on the panel of devices. Return and strongly tighten fixing screws.
9. Establish a clamp.
10. Connect a negative wire to the battery and check up serviceability of functioning of a central air of air.
11. Establish into place an autoradio tape recorder/compact player.
12. Establish the central section of furnish of the panel of devices (track reliability защелкивания all provided clamps). Screw and tighten fixing screws. |
|
Adjustment приводных cables
| |
| 1. Disconnect a negative wire from the battery.
|
|
If the stereosystem established on the car is equipped by a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action! |
2. Translate the handle of the selector of a choice of a direction of distribution of air in position обдува a windscreen. Shift the lever corresponding демпфера against the stop inside and connect to it приводной a cable. Adjust a cable tightness.
3. Translate the lever of a choice of a mode of air circulation in position of the closed circulation. Shift against the stop inside демпферную заслонку and connect a cable to приводному to the lever. In the demanded image adjust a tightness. |
|
|
|