Mitsubishi Galant
+ Identification numbers of the car
+ Controls
+ Options and routine maintenance
+ The engine
+ Cooling and heating systems
+ The power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Manual transmission
+ Coupling and transmission a line
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
Specifications
Search of causes of failures of an electric equipment
Electric sockets - the general data
Protection of electric contours
The relay - the general information and check of serviceability of functioning
Check of serviceability of functioning and replacement of the breaker of indexes of turns/alarm systems
Removal and installation подрулевых the combined switches and the switch of the lock of ignition
Removal and installation of switches
Removal and installation of block headlights of tight type
Adjustment of a direction of optical axes of head headlights
Replacement of lamps of lighting devices
Removal and installation of a combination of devices
Replacement of measuring instruments of a combination of devices
Control system of speed (темпостат) - the general information and a problem diagnostics
System of additional safety (SRS) - the general information and safety measures
Removal and radio tape recorder/CD-player installation
Removal and CD-changer installation
Removal and installation of loudspeakers
Removal and installation of levers of screen wipers
Removal and installation of the electromotor of a drive of screen wipers
Schemes of electric connections - the general information
+ Schemes of electric connections
|
Removal and installation of a combination of devices
|
|
Models of cars considered in the present Management are equipped by system of additional safety (SRS). Before to start performance of any works near to the block of a pillow of safety, a steering column or the instrument panel, disconnect SRS in order to avoid reception of traumas at its casual operation (the Section System of additional safety (SRS) - the general information and safety measures see). Electroconducting of chain SRS is easy for distinguishing on yellow colour of isolation. |
Models Mirage
Removal
|
|
|
1. Disconnect a negative wire from the battery.
|
|
If the stereosystem established on the car is equipped by a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action! |
2. Remove the central section of furnish of the panel of devices.
3. Remove a knee emphasis.
4. Remove facing of an instrument guard.
5. Dismantle a combination of devices and remove from it measuring instruments requiring replacement / control lamps (the Section Replacement of measuring instruments of a combination of devices see).
|
|
At speedometer removal on models with тросовым a drive of the last the cable nozzle is disconnected from a measuring instrument by поворачивания it to the right or to the left. |
|
|
Installation
|
|
|
1. Installation is made upside-down, - try not to damage the printed-circuit board and measuring instruments of a combination of devices.
2. In summary connect a negative wire to the battery and check up serviceability of functioning of all measuring instruments of an instrument guard. |
|
Models Galant
Removal
|
|
|
1. Disconnect a negative wire from the battery.
|
|
If the stereosystem established on the car is equipped by a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action! |
2. Turn out two fixing screws, and cautiously remove from the panel of devices a combination peak.
|
|
3. Turn out four fixing screws and remove a combination of devices in gathering with facing.
|
|
On some models necessity of a detachment from an electroconducting combination is absent, - the printed-circuit board is equipped штыревыми by the sockets automatically connected at its installation. |
|
4. Dismantle facing and remove measuring instruments requiring replacement / control lamps (the Section Replacement of measuring instruments of a combination of devices see).
|
|
At speedometer removal on models with тросовым a drive of the last the cable nozzle is disconnected from a measuring instrument by поворачивания it to the right or to the left. |
|
|
Installation
|
|
|
1. Installation is made upside-down, - try not to damage the printed-circuit board and measuring instruments of a combination of devices.
2. In summary connect a negative wire to the battery and check up serviceability of functioning of all measuring instruments of an instrument guard. |
|
Models Diamante
Removal
|
|
|
1. Disconnect a negative wire from the battery.
|
|
If the stereosystem established on the car is equipped by a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action! |
2. Remove from the knee emphasis located under a steering column switches and the drive handle отпускания the cowl lock. Turn out opened screws and remove an emphasis.
3. Remove the top and bottom sections of a casing of a steering column.
4. Remove facing of an instrument guard.
5. Dismantle a combination of devices and remove from it measuring instruments requiring replacement / control lamps (the Section Replacement of measuring instruments of a combination of devices see).
|
|
At speedometer removal on models with тросовым a drive of the last the cable nozzle is disconnected from a measuring instrument by поворачивания it to the right or to the left. |
|
|
Installation
|
|
|
1. Installation is made upside-down, - try not to damage the printed-circuit board and measuring instruments of a combination of devices.
2. In summary connect a negative wire to the battery and check up serviceability of functioning of all measuring instruments of an instrument guard. |
|
|
|
