Mitsubishi Galant
+ Identification numbers of the car
+ Controls
+ Options and routine maintenance
+ The engine
+ Cooling and heating systems
+ The power supply system and release
+ Engine electric equipment
+ Control systems of the engine
+ Manual transmission
+ Coupling and transmission a line
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
Specifications
Search of causes of failures of an electric equipment
Electric sockets - the general data
Protection of electric contours
The relay - the general information and check of serviceability of functioning
Check of serviceability of functioning and replacement of the breaker of indexes of turns/alarm systems
Removal and installation подрулевых the combined switches and the switch of the lock of ignition
Removal and installation of switches
Removal and installation of block headlights of tight type
Adjustment of a direction of optical axes of head headlights
Replacement of lamps of lighting devices
Removal and installation of a combination of devices
Replacement of measuring instruments of a combination of devices
Control system of speed (темпостат) - the general information and a problem diagnostics
System of additional safety (SRS) - the general information and safety measures
Removal and radio tape recorder/CD-player installation
Removal and CD-changer installation
Removal and installation of loudspeakers
Removal and installation of levers of screen wipers
Removal and installation of the electromotor of a drive of screen wipers
Schemes of electric connections - the general information
+ Schemes of electric connections
|
Replacement of lamps of lighting devices
|
|
The card of used lamps and the scheme of an arrangement of lighting devices are led in Specifications to the present Chapter. |
Head headlights of the combined type
|
|
|
|
In head headlights lamps галогенного type can be used. Закачанный in flasks of such lamps gas is under pressure that demands extra care in circulation with a headlight, casual damage of a flask can lead to hit of splinters in eyes. At service галогенных headlights strictly adhere to following recommendations:
· Start a lamp reversing only after its definitive cooling. Do not include a headlight before end of procedure of replacement of lamps;
· Replacement of lamps carry out in goggles;
· At replacement of lamps avoid a touch to their flasks, - try to hold a lamp exclusively for a socle;
· Try not to shake a lamp and not to drop them;
· Try not to suppose hit on a dirt and moisture flask;
· the Failed lamps before recycling place in regular cardboard packing from under a new lamp. |
|
|
Removal
|
|
|
1. Open a cowl and prop up it in open position.
2. Disconnect a negative wire from the battery.
|
|
If the stereosystem established on the car is equipped by a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action! |
|
|
3. Having turned clockwise and having pulled outside, remove a cover ламподержателя. |
4. Cautiously turning counter-clockwise, take from a casing of a headlight a cartridge with a lamp.
|
|
5. Holding a lamp for a socle, liberate it from a cartridge. |
|
|
Installation
|
|
|
1. Holding a lamp for a socle, accurately fill it in a cartridge.
2. Plant assemblage in a casing of a block headlight and, having turned, reliably it block.
3. Having pressed and having turned counter-clockwise, establish into place a protective cover ламподержателя. Make sure of reliability of planting of a cover in order to avoid hit in assemblage of a moisture or infringement of focusing of light beams.
4. Connect a negative wire to the battery and check up serviceability of functioning of head headlights. |
|
Forward парковочные and dimensional fires
Removal
|
|
|
1. Disconnect a negative wire from the battery.
|
|
If the stereosystem established on the car is equipped by a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action! |
2. Remove limiting access to corresponding lamp components.
|
|
3. Turn ламподержатель counter-clockwise and take it from the landing place. |
|
|
4. For liberation of a lamp from a cartridge pull it along the axis. |
|
|
Installation
|
|
|
Installation is made upside-down. Do not forget to connect a negative wire to the battery and to check up serviceability of functioning of lighting devices. |
|
Forward indexes of turns
Removal
|
|
|
1. Disconnect a negative wire from the battery.
|
|
If the stereosystem established on the car is equipped by a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action! |
|
|
2. Turn out two screws of fastening of a lens of the index of turn. |
|
|
3. Liberate assemblage of the index from кузовной panels. |
|
|
4. Turn ламподержатель counter-clockwise and take it from index assemblage. |
|
|
5. For liberation of a lamp from a cartridge pull it along the axis. |
|
|
Installation
|
|
|
Installation is made upside-down. Do not forget to connect a negative wire to the battery and to check up serviceability of functioning of lighting devices. |
|
Back indexes of turns, stoplights and dimensional fires
Removal
|
|
|
1. Disconnect a negative wire from the battery.
|
|
If the stereosystem established on the car is equipped by a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action! |
2. Open a door of a back/cover of a luggage space. Disconnect corresponding electroconducting, release clamps and remove the back panel of furnish of assemblage of the corresponding back combined lantern.
|
|
3. Having turned, liberate corresponding ламподержатель from a casing of lantern assemblage. |
|
|
4. For liberation of a lamp from a cartridge press it downwards and turn on 1/8 turns counter-clockwise. Having pulled, take a lamp from ламподержателя. |
|
|
Installation
|
|
|
Installation is made upside-down. Do not forget to connect a negative wire to the battery and to check up serviceability of functioning of lighting devices. |
|
Backing fires
Removal
|
|
|
1. Disconnect a negative wire from the battery.
|
|
If the stereosystem established on the car is equipped by a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action! |
2. Open a luggage space cover.
|
|
3. At a corresponding complete set remove the finishing panel established from the interior of a luggage space cover. |
|
|
4. Turn ламподержатель on 1/4 turns counter-clockwise and liberate it from assemblage of a corresponding lantern. |
|
|
5. For liberation of a lamp from a cartridge pull it along the axis. |
|
|
Installation
|
|
|
Installation is made upside-down. Do not forget to connect a negative wire to the battery and to check up serviceability of functioning of lighting devices. |
|
Lateral dimensional fires
Removal
|
|
|
1. Turn out two fixing screws and remove assemblage of a corresponding lantern with кузовной car panels.
|
|
2. Turn ламподержатель counter-clockwise and liberate it from lantern assemblage. |
|
|
3. For liberation of a lamp from a cartridge pull it along the axis. |
|
|
Installation
|
|
|
Installation is made upside-down. |
|
Top level Stoplights
Models Galant 1994 ÷ 1998 of вып.
Removal
|
|
|
1. Disconnect a negative wire from the battery.
|
|
If the stereosystem established on the car is equipped by a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action! |
|
|
2. Open a cover of a luggage space and disconnect electroconducting from assemblage of a stoplight of top level, - access to a stoplight opens from under back салонной regiments. |
3. Turn out fixing screws and take ламподержатель from stoplight assemblage.
4. Slightly having pressed, turn a lamp clockwise and liberate a lamp from a cartridge.
|
|
Installation
|
|
|
Installation is made upside-down. Do not forget to connect a negative wire to the battery and to check up serviceability of functioning of lighting devices. |
|
Models Mirage on 1996 вып, Galant on 1993 вып. And Diamante 1992 ÷ 1996 of вып.
Removal
|
|
|
1. Disconnect a negative wire from the battery.
|
|
If the stereosystem established on the car is equipped by a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action! |
2. On models Mirage and Galant release square clamps or fixing bolts and remove from assemblage of a stoplight of top level a cover.
3. On models Diamante for cover removal it is necessary to wring out accurately inside its lateral which.
4. Press a lamp inside, turn it clockwise and take from a cartridge ламподержателя. |
|
Installation
|
|
|
Installation is made upside-down. Do not forget to connect a negative wire to the battery and to check up serviceability of functioning of lighting devices. |
|
Models Mirage since 1997 вып., Galant since 1999 вып. And Diamante since 1997 вып.
Removal
|
|
|
1. Disconnect a negative wire from the battery.
|
|
If the stereosystem established on the car is equipped by a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action! |
2. Open a cover of a luggage space and disconnect electroconducting from assemblage of a stoplight of top level, - access to a stoplight opens from under back салонной regiments.
3. Turn ламподержатель counter-clockwise and liberate it from lantern assemblage.
4. Slightly having pressed, turn a lamp clockwise and liberate a lamp from a cartridge. |
|
Installation
|
|
|
Installation is made upside-down. Do not forget to connect a negative wire to the battery and to check up serviceability of functioning of lighting devices. |
|
Lanterns of illumination of licence plate
Removal
|
|
|
1. Disconnect a negative wire from the battery.
|
|
If the stereosystem established on the car is equipped by a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action! |
|
|
2. Turn out two screws of fastening of a lens of a lantern of illumination of licence plate. |
|
|
3. Remove a lens from a back wall of a cover of a luggage space. |
|
|
4. Having pulled on itself, take a lamp from a cartridge ламподержателя. |
|
|
Installation
|
|
|
Installation is made upside-down. Do not forget to connect a negative wire to the battery and to check up serviceability of functioning of lighting devices. |
|
Салонные fixtures
Removal
|
|
|
1. Accurately having hooked a small screw-driver, remove a plafond of the corresponding fixture.
|
|
2. Liberate a lamp from spring contacts.
|
|
If the lamp is equipped by cone-shaped socles, slightly wring out a lock clamp / a contact spring. |
|
|
|
Installation
|
|
|
1. Check up a condition of working surfaces of contacts, in case of need make them зачистку.
2. Installation is made upside-down. Track reliability of fixing of a lamp in a cartridge.
3. In summary make sure of serviceability of functioning of fixtures, then establish into place a plafond. |
|
Lamps of illumination of an instrument guard
Removal
|
|
|
1. Disconnect a negative wire from the battery.
|
|
If the stereosystem established on the car is equipped by a security code before to disconnect the battery make sure that have a correct combination for audiosystem input in action! |
2. Remove a combination of devices (see Has undressed Removal and installation of a combination of devices).
|
|
3. Turn ламподержатель a lamp requiring replacement counter-clockwise and remove it from assemblage of a combination of devices. |
|
|
4. For liberation of a lamp from a cartridge pull it along the axis. |
|
|
Installation
|
|
|
|
1. Installation is made upside-down, - in case of need transfer a colour cap on a new lamp. |
2. Do not forget to connect a negative wire to the battery and to check up serviceability of functioning of lighting devices. |
|
|
|
