Mitsubishi Galant

2. Disconnect electroconducting from the gauge-switch of stoplights.
3. Release a counternut and take away the gauge-switch from a pedal so.

4. Release a counternut of a cutting finger of a rod of a pusher and rotation of the last adjust height of position of a pedal, - rotate a rod flat-nose pliers. Having achieved satisfactory result, tighten a counternut.

5. Return the gauge-switch of stoplights in regular position (the Section Replacement of the gauge-switch of stoplights see) and tighten a counternut.
6. Connect to the gauge-switch electroconducting.
7. Check up serviceability of functioning of stoplights (the Section Replacement of the gauge-switch of stoplights see).

1. At the muffled engine some times squeeze out a pedal of a foot brake for the purpose of dump of residual depression in the vacuum amplifier.

2. Completely having dumped depression in the amplifier, press a pedal a hand and estimate size of its course till the moment of occurrence of resistance. Demanded value makes 3 ч 8 mm.

3. At excessively low size of a free course of a pedal check up correctness of adjustment of the gauge-switch of stoplights.
4. Excessive люфт it is usually connected with deterioration of a cutting finger / its pin or a basic arm of a pedal. Replace defective components.